My Blog

A degree of skill is needed to make a number of reliable soldered joints quickly. If flux residue is thoroughly cleaned, soldering can produce a long-lasting connection at low cost. However, the use of an open flame for heating joints can present fire and health hazards to building occupants, and requires adequate ventilation. Of course, they can be fitted on the standard threaded connectors, the end of the pipe just has to be provided with a stan- dardised 37° flare cone in preparation for fitting. If the pipes are not having special ends or plain ends then adaptors make them threaded either male or female whichever is needed.

“plumbing – How do I make my bathroom pipes more practical? – Home Improvement Stack Exchange”. This is also an indication that a clean-out fitting could be installed to provide easier future access. Cast iron piping was traditionally made with one “spigot” end and one “socket” or “hub” end (cup-shaped).

They are categorized by application, such as isolation, throttling, and non-return. At BES, experience is everything, and our customer experience reflects as such. With an excellent rating from thousands of reviews on Reviews.co.uk, we take pride in helping customers across Great Britain source parts for plumbing, heating and gas quickly. And with free delivery on qualifying orders, you’ll be able to save when you shop with us. In straight tee, the diameter of the branch is the same as the diameter of the Run Pipe. Sign up for exclusive offers and expert tipsRegister Your connection to this website is secure.

black pipe fitting

Why not take a look at our range of stainless steel products or get in touch to speak to a NERO representative today. With sealing cone screw-on ttings with O-ring (AOL / AOS), the pre-stressing of the O-ring must be bridged and the sealing cone must lie metallically ush against the cone of the HL/HS connector. Cutting ring ttings are available with a wide range of standardised screw-in threads, enabling them to be used for an enormous variety of applications. All fittings are designed to withstand the operating pressures specified in the standards, in some cases the requirements of the standard are exceeded. “plumbing – In slip joints, what’s the difference between rubber and nylon washers? – Home Improvement Stack Exchange”.

PTFE tape and pipe joint compound (also known as “pipe dope”) should only be used on “IPS” (“iron pipe size”) threads, which are normal pipe threads. IPS threads make their seal along the threads themselves; when a piece of IPS-threaded pipe is screwed into a fitting, PTFE tape and/or pipe dope is used to assist that seal on the threads. Flare fittings, on the other hand, seal on the beveled ends of the fittings, and so using pipe dope or tape on flare threads could actually prevent the fittings from making an adequate seal. The chief advantage of these connectors is that they can be installed after cutting the pipe to length in the field. This can save time and considerable expense compared to flange connections, which must be factory- or field-welded to pipe segments. However, mechanically fastened joints are sensitive to residual and thickness stresses caused by dissimilar metals and temperature changes.